Avidyne Entegra is an integrated aircraft instrumentation system, produced by Avidyne Corporation, consisting of a primary flight display (PFD), and. Release 3 and Later Installation Manual (), () P/N Rev 04 Installation Manual P/N Rev 04 Document. Entegra PFD Series. The Avidyne Entegra EXP brings the advantages of integrated flight deck technology to the retrofit market for business and general.
|Published (Last):||17 August 2010|
|PDF File Size:||9.66 Mb|
|ePub File Size:||9.37 Mb|
|Price:||Free* [*Free Regsitration Required]|
Installing the 2-Way Datalink Antenna Erroneous airspeed indications in combination with erroneous attitude indications. Aircraft Setup options are described in the following sections: There is a button labelled, “TWX Config,” that goes to another menu with the following options all check boxes: The message will remain until the self-test is finished.
Abidyne the Fault fields do not flash, the Calibration Page is only open in display mode and you cannot make changes. See Table 21 and Table 22 for information about the options that may display.
Be the first to review this item 0. Connect the lightning sensor jumpers for correct stabilization source and antenna position. The Knob button will display in the lower left corner. If the Roll Trim button displays, adjust the roll trim as described in Section 5. The Aircraft Setup Page displays: Avidyne suggests that you restart the system after you make changes to each setup page. Lightning and Datalink Sensor Wiring The available options are dependent on the aircraft model and additional purchased features.
Additionally, an FAA-approved Flight Manual Supplement is required and must be carried aboard the aircraft during all flights. Enhanced Fight Director capability of the DFC90 is vastly improved and greatly improves the ability to hand-fly approaches. The final list of affected PFDs may sxp5000 based on the results of Avidyne’s investigation.
See the operating guide for the Lightning Sensor for more information.
These settings will also be set in the MFD and must agree. Connect as shown in I. If the value is out of range, repeat step N. Follow the setup instructions in Section 5.
Warranty & Support
Only use Track if Heading is not available. Repeat Steps 2 and 3 of this section. If using the NMEA format use the 2nd channel. Port selection must match the aircraft wiring. The conditions and tests required for TSO approval of this article are minimum performance standards. For problem reporting, please provide as many details associated with the problem as possible.
Check that the tilt table is set for 0o roll. Radar Sensor Error Messages The Dxp5000 Datalink system avidyn in the S-band at 2. It can also cause an intermittent connection, which will result in an unsuccessful data update. These cables provide a simplified connection to the pre-existing wiring. Two-Way Datalink messages display as Narrowcast. Connect data lines and configure as shown in Appendix I: Cirrus became the first customer of the Entegra system and began offering it on the SR20 and SR22 aircraft in as the first integrated flight deck for light general aviation GA.
In that instance, running the utility yet again will re-activate CMax. These options may include: Traffic System Configuration Options Information in this document is subject to change without notice. RS 4 is the default assignment, but not mandatory. Miscellaneous This Agreement avkdyne be governed by the internal laws of the State of Massachusetts. Select enable the appropriate Narrowcast transceiver as follows: Avidyne makes no commitment to review or avidyen the information contained within the data files with you, and you agree that you have no expectation that this information will be reviewed or shared.
The MFD may be wired to the aircraft dimming bus to control front panel LED brightness via the cockpit panel brightness control.
Avidyne DFC90 Attitude-Based Digital Autopilot
The Traffic Setup Page displays. Green check marks will appear next to each option if exp500 TWX agrees with the configuration. Use shielded wiring, terminated at each expp5000 to chassis ground. These data files are an integral part of the Software as they assist Avidyne in testing and assessing the performance of the Software and the EX or EX This Software contains dated information.
The WX simulation setting is used in conjunction with the demo mode on the sensor to simulate operations on the ground. If selected, a checkmark displays. AC B, Recommended Radiation Safety, sets forth recommended radiation safety precautions to be taken by personnel when operating airborne weather radar on the ground. When the system opens in calibration mode, avidynf Fault fields will flash briefly.