ACOPOS also perfectly suited for CNC applications. ACOPOS in the POWERLINK network. .. ACOPOS , Model number. Short description. Figure. Servo drives. 8V ACOPOS servo drive, 3x V, 34 A, 16 kW, line filter, in- tegrated braking resistor. ACOPOS. USER’S MANUAL. (V1). Version: (February ). Mod. No.: MAACP1-E. We reserve the right to change the contents of this manual without.
|Published (Last):||2 March 2013|
|PDF File Size:||13.56 Mb|
|ePub File Size:||20.43 Mb|
|Price:||Free* [*Free Regsitration Required]|
8V – B&R Industrial Automation
Device Power without Braking Resistor Approx. Additional EMC measures must be implemented by the manufacturer of machines or systems if the product standards for the machine has lower limits or if the machine should conform to generic standard IEC The installation of a central line filter is mostly acopoz in such cases.
Proof of conformity to the scopos limits must be provided according to the documentation for use of the EMC guidelines from the manufacturer or distributor of the machine or system. Twisting or extending the protective mesh using single conductors is not allowed. The same cross section as the power mains protective ground conductor must be used.
Make sure the cable shield is grounded properly. The cable shield must be connected using the designated clamp in the metallic or metal plated plug housing. The fastening screws must be tightened.
Cable connection via terminals: The cable shield must be attached to the shield connection terminal. Cable connection via RJ45 plug: Acopow grounding the cable shield provides an improvement in EMC properties.
Grounding should take place on both sides, extensively and near to the connector.
Grounding of the motor cable on the ACOPOS servo drive 3120 On the motor side, the cable shield for the motor line is connected to the motor housing using the motor plug and connected to ground via the machine.
The cable shield on the connection cable for the external acopis resistor must be connected with the housing of the braking resistor. Connecting Cables to Plug-in Modules Stress relief for the cable is implemented using a cable tie.
The cable tie is to be run ackpos the eye on the bottom of the plug-in module. This makes it possible to activate the holding brake using an external safety circuit independent of the control integrated in the ACOPOS servo drive. Chapter 5 Wiring Table For information concerning dimensioning see section 1.
Before turning on the servo drive, make sure that the housing is properly connected to ground PE rail. The ground connection must be made, even when testing the servo drive or when operating it for a short time!
It’s a community-based project which helps to repair anything.